Advent ADV25 Guia de Instalação

Consulte online ou descarregue Guia de Instalação para Eletrónica para veículos motorizados Advent ADV25. Advent ADV25 Installation guide Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 0
Installation Guide
ADV25
8.5" OVERHEAD LCD MONITOR
WITH DVD PLAYER
RR
Vista de página 0
1 2 3 4 5 6 ... 14 15

Resumo do Conteúdo

Página 1 - Installation Guide

Installation GuideADV258.5" OVERHEAD LCD MONITORWITH DVD PLAYERRR

Página 2 - Important Note

8MOUNTING THE TRIM RINGRoofRoof SupportHeadlinerMounting BracketSelf-drilling ScrewsTrim RingVideo UnitM5 Screw

Página 3 - TOOLS REQUIRED:

91) Make the connections to the vehicle for the 12 pin wiring harness.2) Connect power harness to vehicle’s electrical system by tapping into an acces

Página 4 - Installing The Snap On Covers

10ADV25Figure A * Antenna for Wireless FM Mod.** See Antenna Note on the previous pageANT.INRF OUTOUTFUSEDC INRed RCA (Audio Right)Clean the IR Re

Página 5 - Snap On Cover (Shroud)

11CONNECTING THE DOME LIGHTSThe dome lights in the video monitor require three connections to the vehicle's wiring. There are two common types of

Página 6 - VEHICLE PREPARATION:

12Negative Switched Dome LightingRed / black - Lamp onTo 12 pinconnectorToconstantToconstantBlack / red - Lamp commonPurple / brown - Lamp AutoFactory

Página 7

© 2006 ADVENT, 150 Marcus Blvd. Hauppauge, NY 11788128-7641

Página 8 - TRIM RING INSTALLATION:

An LCD panel and / or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is use

Página 9

1MATERIALS INCLUDED IN THIS PACKAGE:1) ADV25 TV / Video Monitor with DVD – (1pc)2) 12 Pin Power / Signal harness (P/N 112-3483) – (1pc)3) 2 Pin Power

Página 10 - MOUNTING THE TRIM RING

2Housingcatch catchInstalling The Snap On CoversBegin by hooking area “A” (above) over the dome light and slide the cover over the pod. The cover will

Página 11

31 2 3654Work on a soft surface to avoid damaging the plastic.Insert the supplied pry tool between the Housing and Snap On Cover (Shroud), then press

Página 12 - Figure A

4VEHICLE PREPARATION:1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off), and also a good gro

Página 13 - Factory Dome light circuit

5GENERAL SYSTEM CONFIGURATIONS:The following is intended to provide some of the system configurations that are possible with the ADV25D

Página 14 - Troubleshooting:

6Tape marker to screwdriver.Starting at your mark for thelowest point, trace the contour of the roofLowest point markCut lineHeadlinerTRIM RING INSTAL

Página 15 - 128-7641

7TRIM RING INSTALLATION:Supplied screws as below use for install Trim Ring to unit. Please refer illustration below.A) #4 x 5/16 Self Tapping Screws (

Comentários a estes Manuais

Sem comentários