Advent OVERHEAD LED BACKLIT LCD MONITOR Guia de Instalação

RINSTALLATION GUIDEADVDLX1010.1” OVERHEAD LED BACKLITLCD MONITOR WITH DVD PLAYER

4. Locate the #4 x 5/16” self-tapping screw in the hardware kit.5. Using a screwdriver, install the #4 x 5/16” self-tapping screw into the location

9GENERAL VEHICLE INSTALLATION APPROACH1. Decide upon system conguration and options that will be installed (i.e.: what components, Video Game, exte

10VEHICLE PREPARATION1. Locate an accessory +12v power source with a good ground. These wires can be found at the ignition switch or fuse-box. Pow

11CONNECTING THE DOME LIGHTSThe dome lights in the video monitor require three connections to the vehicle’s wiring. There are two common types of dome

12To 3 pinconnectoron MonitorTo constant+12 VDCTo constant+12 VDCFactory Door AjarSwitch or BodyControl ComputerRed-Lamp ONBlack-Lamp CommonPurple-Lam

13INSTALLING THE MOUNTING BRACKET*Self-drilling ScrewsMounting BracketHeadlinerRoof Cross-MemberRoof(4 x Self DrillingScrews - #8 x 3/8”) Mounting Bra

14INSTALLING THE ADVDLX10 VIDEO SYSTEM1. Connect the 6 pin harness to the unit and make the connections to the vehicle.2. Connect the red and black

15INSTALLING ADVDLX10 VIDEO SYSTEMMountingBracketHeadlinerRoof4 x M5ScrewsVideo UnitFrontof VehicleMounting BracketMounting HolesInstalling the ADVDLX

16Snap-inInstalling the Screw Caps1. After the unit is mounted to the headliner, install the two snap in Screw Caps. The snap in Screw Caps are mar

TROUBLESHOOTING SYMPTOM: REMEDY: No power at Video Monitor Verify +12 VDC on the Red wire at 6 Pin Power Harness

Removing the Shroud1. Insert the supplied pry tool between the Housing and Shroud and disengage the tape in the front and back.2. Press the pry too

19APPENDIX B INSTALLING THE OPTIONAL THICK TRIM RING1. Apply masking tape to the outside of the thick trim ring.2. Mark the cut

NOTES:20

© 2014 VOXX ELECTRONICS CORP., 150 Marcus Blvd. Hauppauge, NY 11788 128-9209C

TABLE OF CONTENTSIMPORTANT NOTICES ...

IMPORTANT NOTICES2Installation of overhead products requires careful planning and preparation. Be extremely careful when working on a vehicle with sid

3The following is intended to provide some of the system congurations that are possible with the ADVDLX10 Overhead LED Backlit LCD Monitor with DVD P

4MATERIALS INCLUDED IN THIS PACKAGE1. 10.1” TFT LCD Overhead Monitor With DVD Player - (1 pc)2. Hardware Package (P/N 150-1661) - (1 pkg)M3 x 8mm

3.2. 4.1. 5. 6.INSTALLING THE UNIT IN A VEHICLE Tools RequiredInstalling the Snap On CoversThe ADVDLX10 is supplied with black, shale and pewter plast

6Installing the Shroud1. Remove the tape backing from the front and rear areas at the bottom of the shroud.2. Hook the shroud over the dome ligh

7Installing the Trim Ring1. Turn the DVD Player over on a surface with protective covering to prevent scratches.2. Using a screwdriver, remove the t